For the junction of walls and ceiling, putty is often used. Being a complex and very painstaking process, puttying in many respects should have a high quality of the process, since the final view of the room depends on this aspect.
It is worth remembering the fact that even the smallest and most insignificant mistakes can change the whole process and outcome. The most difficult places are considered to be just the same joints of walls and ceilings, for the reason that such places are hard to reach and in some cases unsuitable for processing.
Each of us would like to complete the repair process as quickly as possible, and for this we will have to take into account several aspects that are often found among beginners.
- There is an ambiguous position that the putty located under the baseboard is an optional item that can be skipped with impunity. This opinion must be refuted, because without layers of putty, the ceiling plinth cannot be forgiven to the surface, and this must be remembered.
- Flat angle. An even angle is a very complex aspect, because it is difficult to fulfill. Often this problem manifests itself in new buildings. In this situation, the corners must be strengthened. It is important to remember that reinforcing parts always fall on the second layer. We do not recommend you to use a sickle, as it is cheap, but it is quite difficult to align the angle with it. Serpyanka constantly lags behind the base.
- Alignment of the corners occurs, both with the help of cement, and by means of a gypsum mixture. Gypsum is used to a greater extent for residential premises, but for beginners it is worth remembering that with strong impact on the material, it can begin to crumble, which ultimately leads to the destruction of the whole designs. Remember to be sure about drywall constructions.
- Very often, beginners forget that the angle is leveled from bottom to top. Be sure to check all measurements with a level. Also, beginners may forget that in the presence of a number of irregularities, it is necessary to repeat the same actions with a smaller layer of plaster to the ideal state. Be sure to remove excessive rounding from the junction.
- If there is a room with round corners, very often beginners do not take a rubber spatula, but it would be worth taking it. Move the classics from bottom to top and top to bottom, in no case horizontal actions.
-
Storm sewage: how is it arranged and what are its features?
-
Adding bright accents to the interior with taste
-
Why is it important to clean the toilet tank?
-
Why it is worth building half-timbered houses not higher than one floor
-
What are the disadvantages of clinker tiles compared to porcelain stoneware
-
What slopes under the windows are the most practical and durable
-
Errors in the design of the bedroom
-
Is it difficult to replace the laminate in the place of damage?
-
Original facade with triangular windows
-
Installation technology of ventilated facades
-
The main disadvantages of half-timbered garage
-
The main thing about soundproofing houses
New publications are published daily on our channel in Yandex. Zen
Go to Yandex. Zen
