How to use a miter saw: basic rules

The miter saw can be used both at home and in the workshop. It has a wide range of features. To choose the right model, you need to understand the features of its use.

What is a miter saw for?

This type of saw allows you to get even and accurate cuts on the surface. You can not observe the angle of 90 degrees, but act arbitrarily. Trimming the model is often used in fine finishing. Many use it when working with door platbands.

Most often it is used when cutting wood or metal. The tool allows you to fix crooked joints on architraves or skirting boards.

A saw can help when laying parquet and assembling doors. She also copes with expensive and durable materials, sawing them across.

How to use a miter saw

When the saw is selected, it must be adjusted. Then it will be ready for use. You have to act according to the rules. And you need to figure out how to control the tool depending on the material being processed.

woodwork

A trigger switch is used to start. But the tool will not start making cuts until the lock lever is pressed. After that, the equipment is lowered to the material. Before work, it is recommended to wear protective equipment to protect yourself from chips that will appear during wood processing.

A wooden blank should be held by hand if the cutting is at a right angle. But if the work is done by a beginner, it is recommended to use a clamp. It keeps the material still, allowing you to focus on cutting. A clamp is definitely needed if the workpieces are not worked at a right angle, but at any other.

To correct the cutting angle, you must use the platform turn. It is necessary to unscrew the handle, which acts as a rotary lock, and press it down. The platform is ready to move.

Attention! Changing the angle increases the cutting area. This reduces the ease of use of the saw, so clamps must be used.

To change the angle of the wood cut, you can use the vertical slope of the trimming. The fixation handle is first loosened, the desired slope is set and re-fixed.

For metal

Before turning on the tool, you need to make sure that its nodes are reliable and that the disk can move freely. To make a bevel cut, loosen the fixing screw at the turntable and start turning it to the desired angle. The set position is fixed immediately. If the work is long, periodically check how accurate the trimming is. This is due to the fact that after some time the fixing screw loosens.

If you want to saw with a left-hand slope, then it must be set correctly. The fixing screw for fastening the inclined angle is released and the desired angle is set. To fix the set parameter, the screw is tightly tightened. After that, the cut continues.

Important! When the work is finished, after turning off the tool, you must wait until the cutting disc has completely stopped. After that, the handle returns to the up position.

Do not remove the protective cover from the device. It rises when the blade is lowered down to cut.

Miter saw cutting safety

When working with the tool, safety precautions must be observed. Before you start cutting, you should check the performance of each piece of equipment. Fixing parts, casing, various protection systems, etc. must be in good order.

Near the workplace should not be foreign objects, blanks. When turning on the tool, hold the handle firmly. The surface to be cut must be supported by a clamp and firmly fixed. Supports are selected taking into account the material with which they work. It is impossible to cut metal blanks at the same time.

After switching on, the tool should run idle for a few minutes. This will ensure that the unit is working properly. The user should take the most comfortable position. For safety, it is also recommended to use special means to protect your hands and face.